Three-level Voltage Regulator 67.3702-12
1 Installation
1.1 Take out the regular brush unit with regulator.
1.2 Install brush unit (from he set) into generator and fasten it firmly.
1.3 Install socket with cables into the case slot of regulator.
1.4 Install regulator it the convenient place with its base opening on the vacant mass pin (remove dust and rust from the pin first). Fasten it firmly together with cable ring of double mass (from the socket).
1.5 Turn the switch to one of the three positions depending on the need of exploitation:
- «min» position either for operation at high outside temperature (>20ºС) or for unusual operation (traffic jam, upward movement, etc.);
- «mid» position – for operation at outside temperature between 0ºС and 20ºС;
- «max» position - for operation at minus outside temperature and for battery charging.
Note.
In case there is no return from the generator when the engine is free-running (the battery charge lamp is still ON), settle the housing of the attached cable into the vacant place of the socket. Connect the end of this cable with plus cable of the car (AFTER the ignition). Use connector for better tie.