It is intended for automatic control over heating of frameless windscreen brushes depending on the outer temperature and voltage. The unit is a device with outer thermosensor and connective cables.
There is a LED for load indication.
The set includes:
- heating elements - 2 pcs.
- connective sleeve - 4 pcs.
- connective cable - 1 pc.
- cable tie - 4 pcs.
- operation manual.
Application: VAZ 2101-2107, Niva and other with same windscreen brush type and 12V onboard electrical system.
There is a LED for load indication.
The set includes:
- heating elements - 2 pcs.
- connective sleeve - 4 pcs.
- connective cable - 1 pc.
- cable tie - 4 pcs.
- operation manual.
Application: VAZ 2101-2107, Niva and other with same windscreen brush type and 12V onboard electrical system.
Подробнее
Description
Description
Operation manual
1 Setting and adjustment
The unit must be connected while the battery is OFF!
1.1 Place thermosensor in the area of temperature control (under front bumper, for example).
1.2 Place heating elements on the brushes. Mind operation manual.
1.3 Connect control unit according to the scheme (pict.1) use connective cable and sleeves from the set.
Operation manual
1 Setting and adjustment
The unit must be connected while the battery is OFF!
1.1 Place thermosensor in the area of temperature control (under front bumper, for example).
1.2 Place heating elements on the brushes. Mind operation manual.
1.3 Connect control unit according to the scheme (pict.1) use connective cable and sleeves from the set.

1.4 Fasten the cable using the ties from the set.
2 Operation mode
Brushes heating turns ON after the engine start supposed onboard voltage is higher than Uon and thermosensor temperature is lower than Ton.
Brushes heating will turn ON when thermosensor temperature is higher than Toff or onboard voltage is lower than Uoff (aft the engine is stopped).